Two wedge shaped stainless water tanks have been fabricated with a combined capacity of over 40 gallons.

The lower seems of the tank were welded (TIG) inside and out, the top was the welded from the outside once the tank interior had been purged 100% with argon.

The tanks were pressured to 5 psi and soap tested. 0 leaks… so i did it twice. Thankfully I’d had some recent practice at work on a very large stainless hydraulic tank.

The tanks are fastened in with rubber padding, bolt pads, and finally the ash framing that supports the bunks. The install should be sufficient..hopefully even in the event of a roll over.